You do not need to be a scientist in a position to a bottle rocket, but you have it as a concept in the sense that you have the proper tools and materials are available.
First collect all the necessary materials you need to build a bottle rocket. These include a bottle of course. Everyone does, but a 1-liter size soda bottle is preferable.
You also need a bottle of rubber cement, paint thinner (1) can be a roll of duct tape, a hose clamp (1 inch) and aLAF.
You should also include the following: a couple of 2in nails, two pieces of wood, a measuring 2x4x12, and another 6x1/2x18, four sheets of balsa wood (6x4), five screws, an inch long.
An electrical junction box, a 3 "thin steel () about 1 / 8" diameter, a 12-string, a copper tubing 12 "long, and a test tube stopper. In this project, the size will be 4 with an opening in the middle.
As for the tools to prepare a compass, drill scissors, sandpaper, hammer, markerAngle, air compressor, reciprocating saw and a screwdriver. Have the size varies depending on the wood screw you selected.
To build the bottle rocket, start by washing and drying of the soda bottle. Use the paint thinner to remove all the glue and remove the labels, too.
Take the balsa wood, and use the market to a 5x3 format (right-angled triangle) to highlight it. Use the jigsaw to cut the shape, and the use of sandpaper to smooth the edges. These serve as your finsRocket.
Stick the fins on the bottle of rubber cement. Make sure that they are equidistant from each other. The tape is to be used for straightening the fins.
Take a compass and a 4 "circle. Use the scissors to a line from the outer circle cut into the middle. Fold it into a funnel shape. Glue, and add some tape. Put it on top of Your bottle, and you have the nose setup. Let the glue overnight and then you can remove the tape.
Making theLaunching pad for missiles of the bottle is easy. Take the 2x4 wood and cut it in half. Place it so that each about 18 inches apart, Get the 18-inch wood and put it on the 2x4 so that both sides resting upon him. Use the screwdriver to a wood screw drive in the board 18in. Repeat the process is completed on the other side, and the platform.
Next take the junction box and sluggish, a screw, so that the junction box is connected to the platform. Drill a hole in theField so that the test tube stoppers fit in. Put the stopper in it. Insert the copper tubing through the rubber stopper. Connect the compressor with the hose with the hose clamp.
Get the wire and it takes the form of a horseshoe. Fasten the cord in the middle of the horseshoe, and put in an electric field. Drill a hole in each 2x4 piece of wood, and the platform for the bottle rocket ready.
Take the launch pad outside, hammer and some nails into the ground soIt is connected to the earth. For 20 liters of water in the bottle, stuck a needle into his neck, set the compressor bar to 45. Pull the string and you will see your bottle rockets fly.
0 ความคิดเห็น:
แสดงความคิดเห็น